Partial loosening or other problems may occur after a deep throat punch has been used for a period of time. At this time, we need to perform horizontal correction and adjustment operations on it. There are three main methods: 1. First, thoroughly clean the frame of the deep throat punch to increase the accuracy of the horizontal reading; no feeding is required during debugging, but the guide screw on the deflector needs to be raised first, and then elbowed way to adjust the ram slowly to the bottom dead center. At the same time, pay special attention to the guide plate not to press the lift rod too low, otherwise the lift rod will appear zigzag

1. Determination of the reverberation time and noise value of the noise source in the servo micro punch workshop: The reverberation time refers to the indoor sound reaching a stable state. After the sound source stops sounding, the residual sound is reflected back and forth in the room and absorbed by the wall, and the average sound energy density decreases. Time to one millionth of the original value. The longer the reverberation time is, the more time the sound is reflected in the workshop, the slower the energy decays. Under the same sound source condition, the workshop with long reverberation time is more noisy than the workshop with short reverberation time.

If there is air leakage during the use of the high-performance pneumatic punch, it must be dealt with in time, otherwise it will affect our normal use, and may even directly affect its work efficiency. Therefore, air tightness is still very helpful for the use effect. Therefore, for this problem, we have to find the exact reason to deal with it.

The precision punch here is a punch produced with a steel plate welded body. The precision punch is generally composed of an upper die, an upper die holder, a lower die holder, the inclination of the cutting edge, the opposite side pressing block, the guide plate, and the guide post. Its design principle is that circular motion drives linear motion for energy conversion. Based on the main motor, it first drives the flywheel, and then drives the gear, crankshaft, connecting rod and other components to run through the clutch, so that the slider moves in a straight line.