How to maintain and maintain the punch after purchasing the precision high-speed punch to increase the service life of the punch? This question must be one of the most concerned about the enterprise. The following precision high-speed punch manufacturers will briefly introduce the problems that should be paid attention to in the daily maintenance and maintenance of precision high-speed punches:

1. Regularly clean the equipment and check the fastening screws of the foundation.

2. The guide rail crankshaft and connecting rod oiling screw ball head shaft refueling.

3. Lubricate the oil pump of the system, and open the oil pump to supply oil to each lubrication point.

4. Check whether the manipulator, clutch and brake are normal.

5. Check whether the oil circuit and oil pump are in good condition.

6. Regularly check the operation of the drive shaft, copper sleeve and bearing for 3 months, disassemble and refuel or replace.

7. Check the clutch of the manipulator, disassemble and refuel, observe its wear and tear, and repair or replace it.

8. Check the operation of clutch and brake: when "inching", check whether the "inching" and stop angle of the crankshaft are too large.

9. Check the running state of the flywheel: Viewed from the back of the press, the flywheel should rotate clockwise, and the V-belt should not vibrate and slip. The block should stop immediately. When the crankshaft angle turns 160°, release the two-hand button, and the slider should stop at the top dead center.

10. Check whether the indicated value of each pressure scale is within the given range.